Skip homing when loading and unloading filament
Please make the printer skip the homing process when loading or unloading the filament. If the head really needs to be in the corner, then let it do the quick homing with just one bang. The precise homing will happen at the begining of the print anyway -- no need to do it three times.
Especially when unloading the filament, the homing is really annoying. It should be just a short run of the extruder motor. Often it is late in the evening, everyone around is already sleeping, I just need to clean up and turn the printer off, but the printer is like "I shall play you the song of my people!"
RE: Skip homing when loading and unloading filament
A valid request, but unfortunately Prusa does not appear to read this forum. A feature request on Github or a loud post on Reddit seem like the ways to get their attention.
RE: Skip homing when loading and unloading filament
Which is a shame because if they did read this forum, they'd probably learn earlier about the various grounding issues.