Avisos
Vaciar todo
I can't drive... 55
So I've been pushing the chamber temp past the limit meaning > 55°. Can confirm that once it reaches 60° the printer doesn't like that and will signal a thermal runaway shutdown.
Will need to measure the remaining space on my table and see if there is room for an H2D.
Respondido : 13/02/2026 12:03 am
Respondido : 13/02/2026 1:25 am
Topic starter
answered:
RE:
Perhaps I should have added that my bed temp was also 120° so it's possible it's the bed that went above the limit.
Esta publicación ha sido modificada el hace 2 hours por hyiger
Respondido : 13/02/2026 2:54 am