I can't drive... 55
So I've been pushing the chamber temp past the limit meaning > 55°. Can confirm that once it reaches 60° the printer doesn't like that and will signal a thermal runaway shutdown.
Will need to measure the remaining space on my table and see if there is room for an H2D.
RE:
Perhaps I should have added that my bed temp was also 120° so it's possible it's the bed that went above the limit.
RE: I can't drive... 55
Not an issue for me either with my chamber heater, though I havent maxed out the bed in combination with long 60 degree prints. Do you have a heater or insulation?Even without heater it could sit around 58 when printing hot on the bed, the printer doesnt seem to care that it overshoots 55.
RE:
It's not the 55C limit, it overshoots when to gets to 60C with 120C bed. Oh, and the title is reference to a song meaning "I can't stay below the speed limit in my car"