Fixing the Automatic Chamber Vent

Strona 2 / 2 Wstecz

Ostatni Post

RSS

SdeL

(@sdel)

Member

RE: Fixing the Automatic Chamber Vent

It looks as if the vent cannot be moved automatically. Until a few days ago, the printer would systematically interrupt a PLA print, asking to confirm that the vent was open but I do not get that message anymore...

Opublikowany : 03/05/2026 4:10 pm

hyiger

(@hyiger)

Famed Member

Topic starter answered:

RE: Fixing the Automatic Chamber Vent

Posted by: @tri-d

Is it? I just started a PLA print with closed Vent and it stayed closed so I manually had to open it.

The 6.5.3 firmware is supposed to set the vent state based on the chamber temperature setting before every print. I've confirmed it works for me so I have removed the vent open/close logic from my start g-code.

Opublikowany : 03/05/2026 5:05 pm

Strona 2 / 2 Wstecz

Statystyki Forum

598 Fora

71.4 K Tematy

501.7 K Posty

11 Online

82.4 K Członkowie

Ostatni Post: Why did Prusa placed an openprinttag on all filaments and charges for it? Najnowszy użytkownik:: Tim Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte