Does CORE One print well ABS?
Coming from the Voron world, ABS is my goto filament. The CORE One specification does mention ABS but I don't see it mentioned much here in the forum, as opposed to let's say PETG, PC, and TPU.
Does the CORE One prints ABS well?
RE: Does CORE One print well ABS?
Don't know about ABS but it prints ASA beautifully.
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
RE: Does CORE One print well ABS?
From the spec sheet...... PLA, PETG, Flex, PVA, PC, PP, CPE, PVB and when using the optional Advanced Filtration System ABS, ASA, HIPS, PA
So, yes ABS is supported.
RE: Does CORE One print well ABS?
It have printed ABS without any issue. But I would recommend to switch to ASA. ABS is the filament of the past which has not advantages over ASA. It's just bit harder to print.
RE: Does CORE One print well ABS?
At what speed is the Core One capable of printing ASA?
RE: Does CORE One print well ABS?
Good to know. I will give it a try.
It have printed ABS without any issue. But I would recommend to switch to ASA. ABS is the filament of the past which has not advantages over ASA. It's just bit harder to print.
RE: Does CORE One print well ABS?
At what speed is the Core One capable of printing ASA?
With 0.6mm HF nozzle the Prusament ASA filament profile has max volumetric speed set to 34 mm^3/s. That's quite fast. Maybe it's possible to print it even faster, but it may not have good layer bonds if you push it too much.
RE: Does CORE One print well ABS?
Tried ABS-GF on my Core One yesterday and it printed good, I used the generic ABS profile and adjusted temps slightly.
It takes a few minutes to get going as it heats the chamber. Only a smallish part but very nice result, zero warping.