Notifiche
Cancella tutti
COREONE: TOP SURFACE RIPPLES
Hi! This print a some other is going well until the last layer. The filament is PLA Woodfill prusament. The layer height is 0.28mm. Any idea about the cause?
Postato : 20/03/2026 7:10 pm
RE: COREONE: TOP SURFACE RIPPLES
Hello;
if you could please read this post and then provide the needed information so the community can assist you, it would be appreciated.
Thanks
Shane (AKA FromPrusa)
Postato : 23/03/2026 8:09 am
1 persone hanno apprezzato
RE: COREONE: TOP SURFACE RIPPLES
This looks like pretty severe overextrusion.
Try setting your Flow factor to 92% or so and see if it improves. If it does, I suggest doing a proper calibration of the extrusion factor
Postato : 23/03/2026 8:54 am