Replacing Nozzle about the worst thing from enclosure? Thoughts
 
Notifications
Clear all

Replacing Nozzle about the worst thing from enclosure? Thoughts  

  RSS
JandLMak3rs
(@jandlmak3rs)
Eminent Member
Replacing Nozzle about the worst thing from enclosure? Thoughts

Ok. I have tried now twice to do a nozzle replacement from the enclosure and find it sucks. You cannot access the area easily. I would totally prefer doors on the side and might take up the user mod/hack to put doors there. 
Any thoughts, or some trick anyone would like to share to make it easier?

Posted : 30/03/2023 11:35 pm
halfabee
(@halfabee)
Active Member
RE: Replacing Nozzle about the worst thing from enclosure? Thoughts

I prefer to take the printer out of the enclosure to work on it. The hinged lid makes this a little easier

https://www.printables.com/model/273426-hinged-lid-for-adding-mmu2s-to-original-prusa-encl

Plus I have left the control panel attached to the printer instead of on the outside so the only thing I need to do to remove the printer is move the power supply.

But I agree with you, sometimes it would be nice to have easy side access.

Posted : 04/04/2023 1:07 pm
Share: