Prusa XL 24v power supply?
I know this is in 2 places but there are 2 XL forums!! More exposer I guess.
Hey everyone I am about done with my enclosure and will be installing a Nevermore V6 air circulator/ air scrubber. My question I need a 24v supply and cannot find a wiring diagram anywhere for the XL.
Does anyone know if there is a 24v supply that I can wire the Nevermore V6 too? It will also have a inline external switch to turn it on and off.
Thanks ahead of time. Mark
RE: Prusa XL 24v power supply?
any luck?
I'm looking for a safe place to draw 24v for a fan for the electronics compartment (on the theory that the xl-buddy really wants a fan to keep the motor controllers cool)
RE: Prusa XL 24v power supply?
How about, directly from the XL Power Supply?
there are two of them,
a fan shouldn't phase the power supply
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Prusa XL 24v power supply?
I had found the 24v power source on the XL but opted for a separate 24v transformer for the air scrubber. It has worked out nicely.
RE: Prusa XL 24v power supply?
Air scrubber? Interesting project. Can you post pictures?
I had found the 24v power source on the XL but opted for a separate 24v transformer for the air scrubber. It has worked out nicely.
--------------------
Chuck H
3D Printer Review Blog
RE: Prusa XL 24v power supply?
Air scrubber? Interesting project. Can you post pictures?
I had found the 24v power source on the XL but opted for a separate 24v transformer for the air scrubber. It has worked out nicely.
It's on page seven of my Enclosure thread.
RE: Prusa XL 24v power supply?
Air scrubber? Interesting project. Can you post pictures?
I had found the 24v power source on the XL but opted for a separate 24v transformer for the air scrubber. It has worked out nicely.
It's on page seven of my Enclosure thread.
Thanks. I missed a few posts but have been following off and on.
--------------------
Chuck H
3D Printer Review Blog