Obxidian Nozzles
ordered 5 of these nozzles to replace the stock 0.4 brass nozzles with the thinking that i shouldn't be cleaning the nozzle heads before starting a print ( I sometimes forget).
What calibrations do I have to do? i'm thinking not the whole calibration process but just the Nozzle seal height calibration, Loadcell, and just the Offset Tool Calibration.
RE:
Offset tool calibration.
Don't be disappointed but I don't see any improvements in stuff sticking to the nozzle. Certainly not enough to forgo cleaning the nozzle.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
RE: Obxidian Nozzles
See my rather long post about the Obxidian. Nozzle brushes take care of most of the cleaning, but it's really only necessary for multimaterial/multicolor prints.
RE: Obxidian Nozzles
RE: Obxidian Nozzles
thanks.. makes me feel better with my purchase now..
RE: Obxidian Nozzles
Offset tool calibration.
Don't be disappointed but I don't see any improvements in stuff sticking to the nozzle. Certainly not enough to forgo cleaning the nozzle.
Same. They are harder, but still goop up about as much. Thankfully I haven't noticed any significant thermal differences so no recalibration there. Just the offset calibration.
RE: Obxidian Nozzles
Can you mix these with the brass nozzles or can you only calibrate the whole setup?
RE: Obxidian Nozzles
Mixing is fine and you can only calibrate the whole setup, cannot just calibrate one nozzle.
XL-5T, MK3S MMU3 || GUIDE: How to print with multiple-nozzlesizes do read updated replies || PrusaSlicer Fork with multi-nozzlesize freedom || How Feasible is Printing PETG for PLA supports on XL very