Notifications
Clear all
Printer started printing offset mid print.
Anybody know what caused this or how this happened?
The printer started printing offset to the far back left corner about 20% in to the print.
It was even smacking in to the left side rail, including after i hit Stop.
There are a few of these strands that are kicked off to the side which is odd. Hard to figure out what happened here. Slicer looks fine.
Posted : 02/12/2024 5:30 pm
Topic starter
answered:
RE: Printer started printing offset mid print.
Ok I think parts of the print were popping off of the support material in sheets. Not sure how that made it go offset though. And also why it wasn't detecting crash smacking in to the side arm.
Posted : 02/12/2024 7:28 pm