Avisos
Vaciar todo
Página 14 / 14
Anterior
RE: USB error mid print
Just had my first one. Very frustrating, roughly 20 hours into a 2 day print. This XL has been a shit show.
Respondido : 08/07/2025 10:14 pm
RE:
Hi,
I did not read all of the last 14 pages of this thread so maybe this fix is already known: In my case the solution for the USB-error was removing the XL Buddy (processor-) board 5 times and pressing it back into it´s slot. Take care of the WiFi-antenna cable when doing this or disconnect the antenna plug first.
...And gone was my "No USB issue" that has killed nearly all of my prints of the last weeks. So just try this when having weird USB active/inactive behaviour. Of course there should be a lot more reasons why USB does not work, so no fix in all cases.
Micha
Esta publicación ha sido modificada el hace 2 weeks por Michel 0815
Respondido : 19/11/2025 12:36 pm
Página 14 / 14
Anterior