Notifications
Clear all
Systematic auto-levelling error with large prints
Does anybody else have leveling problems with large prints? On my XL, the first layer on the right side of the print bed looks over-extruded due to a too-low Z offset, but only when the print extends all (or most of) the way to the left side of the print bed.
I filed this issue (including images of test prints, and a test 3MF) because after experimenting with this for the last two days I think this is a firmware problem.
However, if anybody can think of an alternate explanation (or even a solution) I'm all ears.
This topic was modified 8 months temu by Matthias U
Opublikowany : 21/04/2024 12:50 pm