Notifications
Clear all
input shaping question
Can anyone tell if the XL has an input shaping sensor?
With the Prusa mini this is not the case.
Napsal : 12/11/2023 6:43 pm
RE: input shaping question
It has an accelerometer. It's unclear if it's being used however (there is certainly no obvious calibration cycle like on other printers).
Napsal : 13/11/2023 1:51 am
RE: input shaping question
I know they said it would have one but is it confirmed the chip/s are there? Anyone taken the Nextruder apart?
It has an accelerometer. It's unclear if it's being used however (there is certainly no obvious calibration cycle like on other printers).
Napsal : 13/11/2023 11:19 am