Notifications
Clear all
Firmware 6.2.2 is a mess
I didn't connect the dots at first, I flashed it this morning before my first attempt. First layers are awful! I first blamed the filament after 3 attempts with bad first layers and put the filament in the oven for half a day, that was not the issue. The nozzle is not low enough so I get stringy garbage, there is a visible gap between the bed and nozzle. And another problem the printer it just crashed head 4 into head 1 which was parked?? WHY?
I already downgraded the firmware
Posted : 27/03/2025 10:30 pm
DLD Design Fab liked