Notifiche
Cancella tutti

Extuder Mintemp error #17208  

  RSS
SasHin
(@sashin)
Utenti
Extuder Mintemp error #17208

After changing the nozzle from 0.6 to 0.4, everything was fine at first.
Then the prints stopped after about 25%, but could be restarted. At the next stop, a restart was not possible: Error #17208.
As seen in the picture, the sensor measures a negative nozzle temperature.
I checked the wiring; no obvious errors.
Firmware update to 6.1.3 does not solve the problem.

I need help.

Postato : 12/10/2024 9:24 am
Condividi: