Crash Problem after Updating to 6.0.3
After Installing the Enclosure and Updating to 6.0.3 The Toolhead "crashes" 1sec before taking a Tool.
The firmware i used before was 6.0.0 RC3
The Toolhead does it at any of the 5 Tools.
Right before it could take the Tool it restarts and then gives the Error Message below.
Is it the Firmware?
Could it be the Enclosure? i didnt really change geometry.
Should i run a complete calibration?
Best Answer by Plastikschmiede:
It was false wiring.
So, maybe a different Error message would be cool.
The Error itself was my fault.
Sometomes its counter intuitive to wire the XL from the back.
RE: Crash Problem after Updating to 6.0.3
I guess maybe i rewired the Toolhead Pins wrong.
The upper 2 Slots are for Extruder 1 and 2
On the Splitter Slot 3-5 are form left to right [Empty] [Tool 5][Tool 4][Tool 3] right?
Could that be the Problem? It the XL checking if a wrong Tool is picked?
https://help.prusa3d.com/de/guide/auswechseln-der-sandwich-platine-xl_650957
If so, a different Message then "Tool Crash" would be awesome.
RE: Crash Problem after Updating to 6.0.3
It was false wiring.
So, maybe a different Error message would be cool.
The Error itself was my fault.
Sometomes its counter intuitive to wire the XL from the back.