Notifications
Clear all
Build play at an angle after leaving something on base
I have made a big mistake. I left something under the build plate overnight without realising now the bill Plate is at a funny angle whatever I try. I can’t get it straight. I tried the calibration for the Z but it just said there was an error does anybody know how I can get this straight again please?
thanks
Posted : 10/01/2026 1:14 pm
First check there is nothing stuck to either the build sheet or the print bed.
Next, is either curved/bent? Place a straightedge across and check.
If anything else - a picture might help us understand.
Cheerio,
Posted : 10/01/2026 5:38 pm