Bonkers benchy gcode wipes on tower before docking, how do I slice that into my own gcode?
I flashed the new XL IS firmware on my printer this weekend and noticed also ran the gcode for the 2 color bonkers benchy.
I noticed watching it print that it had some behaviors that I have identified as solutions to printing defects I've been experiencing on my XL prints. On the bonkers benchy when a toolhead was done for the layer and the second toolhead was about to come in the toolhead first went to the wipe tower and then retracted and docked. This prevented a thick string from being left on the print when the bed lowers for docking and instead it's left on the wipe tower.
I sliced a print of my own with the new Alpha 1 slicer release and it was still doing the old behavior of ending on the model before docking. Where do I set the slicer to go to the wipe tower before docking?