Notifications
Clear all
Bed level off after passing calibrations
Strange one. I've been tuning my XL Multi and noticed the bed was sitting about 1mm lower on the right. It has passed all of its calibrations and even printed reasonably well. Looked up what to check and did the heatbed installation check Step 23 in the first run guide here https://help.prusa3d.com/guide/7-first-run_512915 . That didn't change anything so I remembered someone else mentioned manually turning the lead screw so did that and got the bed level, ran the Z calibration and tool offsets again and all looks fine. Something to look out for or an anomaly?
Publié : 21/01/2024 11:46 am