Avisos
Vaciar todo

XL 2-head Semi-Assembled Build Thread  

  RSS
cwbullet
(@cwbullet)
Miembro
XL 2-head Semi-Assembled Build Thread

Ok, I have had my printer since Tuesday.  I am home for the weekend and plan to build it.  

I opened up the box, and wow! Semiassembled looks pretty much assembled. I will build this tomorrow and post some photos.  I have no opened the box yet, so it might have more complexity than I think.  Tomorrow, we will see!

--------------------
Chuck H
3D Printer Review Blog

Respondido : 12/08/2023 2:15 am
DarkTeck
(@darkteck)
Estimable Member
RE: XL 2-head Semi-Assembled Build Thread

Fingers crossed for you buddy ! Its not a bad build at all its fairly easy and straightforward . Hope to see you with perfect prints ! 

Respondido : 12/08/2023 4:29 am
Johan
(@johan)
Eminent Member
RE: XL 2-head Semi-Assembled Build Thread

Worst part was routing the cable in the bottom frame, a few cursing words came out before it got in place 🙂

 

Respondido : 20/08/2023 9:33 am
cwbullet
(@cwbullet)
Miembro
Topic starter answered:
RE: XL 2-head Semi-Assembled Build Thread

Same here.  I had to redo it several times.  The corners were terrible.  

Posted by: @johan

Worst part was routing the cable in the bottom frame, a few cursing words came out before it got in place 🙂

 

 

--------------------
Chuck H
3D Printer Review Blog

Respondido : 20/08/2023 2:06 pm
cwbullet
(@cwbullet)
Miembro
Topic starter answered:
RE: XL 2-head Semi-Assembled Build Thread

I guess I double posted this stuff:

https://forum.prusa3d.com/forum/original-prusa-xl-tool-changer-general-discussion-announcements-and-releases/prusa-xl-build-thread-two-head-version/#post-669368

--------------------
Chuck H
3D Printer Review Blog

Respondido : 20/08/2023 2:07 pm
Compartir: