X Y horrible noise
I did a full maintenance on my prusa xl as always.
However this time it started making really horrible noise after running calibration.
Have anyone had this issue before? Not sure what did I do wrong to cause this.
RE: X Y horrible noise
Hallo,
vermutlich hast du die Firmware 6.40 auf dem XL installiert, und die Phase Stepping Kalibrierung durchgeführt ?
Falls das zutrifft, installiere die Firmware 6.26 und mache die Phase Stepping Kalibrierung erneut.
RE: X Y horrible noise
What kind of noise is it? If its a screaming type of noise, take a look at this post, could be the firmware:
https://forum.prusa3d.com/forum/postid/777335/
I did a full maintenance on my prusa xl as always.
However this time it started making really horrible noise after running calibration.
Have anyone had this issue before? Not sure what did I do wrong to cause this.
RE:
RE: X Y horrible noise
Flash the 6.2.6 firmware, run your calibrations again. See if noise is gone.
I did a full maintenance on my prusa xl as always.
However this time it started making really horrible noise after running calibration.
Have anyone had this issue before? Not sure what did I do wrong to cause this.