Benachrichtigungen
Alles löschen

Should you order the XL?  

  RSS
BillC
(@billc-2)
Active Member
Should you order the XL?

If you are like I was, you have concerns about the reported print quality and issues such as stringing and banding. I was seriously considering not completing my XL 5 head order, especially with the high cost.

I took a leap of faith and finished my order. I can happily report that I am very pleased with the quality and ease of use of my XL.

With the latest slicer (2.7 rc2) and firmware (5.1 beta), the results are excellent.

If you are considering whether to close the deal on the XL, I highly recommend it. I have lighted the model to highlight the layer lines. They are very hard to see under normal lighting.

Here a couple of pictures of my recently completed 5 color Santa.

Veröffentlicht : 22/11/2023 11:41 pm
ssill2, Acht und Georg gefällt das
Georg
(@georg-2)
Estimable Member
RE: Should you order the XL?

Wow! That print is amazing! Thank you for sharing. 🙂 

Veröffentlicht : 23/11/2023 7:17 pm
Chimeric
(@chimeric)
Active Member
RE: Should you order the XL?

Agree, it has been working well for me also! 

Veröffentlicht : 26/11/2023 12:53 am
Acht gefällt das
ssill2
(@ssill2)
Noble Member
RE: Should you order the XL?

I will I agree, with latest slicer and firmware, it's pretty good.   I've completely disabled filament sensors on the side as they create too much drag, especially on TPU.   However, It's now to where I had hoped it would be when I got it and I expect it will get better and better.

Veröffentlicht : 26/11/2023 6:22 pm
Acht gefällt das
CyberCrist
(@cybercrist)
Active Member
RE: Should you order the XL?

Same experience for me. With VERY minimal threading, not even stringing, like little wispy stuff, I'm already on my 3rd multiday print. I just flashed to 5.1FW and it took my 1d5h print to 19h with IS. 

Veröffentlicht : 26/11/2023 8:03 pm
Teilen: