Avisos
Vaciar todo

Flex filament not possible to load into all heads  

  RSS
Robert
(@robert)
Trusted Member
Flex filament not possible to load into all heads

When loading a Flex (Torwell 92?) filament, it cannot be loaded into heads (1,3,5), but it works well for heads 2 and 4. The filament is pushed into the wider upper metal part of the nozzle correctly, but then the filament starts slipping on nextruder wheel and does not continue to the lower hot-end.

I've tried stretchen nextruder springs, increase the nozzle temperature up to 280C, no success so far. Looks not all nextruders are the same :(.

Are there any other suggestions to improve the loading of flex filament?

Este debate ha sido modificado el hace 8 months por Robert
Respondido : 18/04/2024 7:17 am
Compartir: