Notifiche
Cancella tutti
Extruder Pre-heat warning/crash
Hi, I am trying to print a part in PC w/ HIPS supports. In about the same layer (give or take a couple), I am getting a preheat error (red crash screen). I already changed the heater and thermosensor on that extruder (along with V6 adapter, nozzle, and block) and it didn't make a difference. So far it has always been extruder 5 which is the one with HIPS loaded into it.
Any ideas what to look at? I was running 6.2.0-RC1 and then backdated to 6.1.3. Issue is happening on both.
I can share the gcode if someone want, it isn't anything really special.
Postato : 11/01/2025 6:11 am