Notifications
Clear all
Extruder Error(s) after 6.2.0
After upgrading to 6.2.0 I have experienced two failed prints, both with "Extruder Error - motor is not spinning on tool X" (on both tool 1 and tool 2 thus far)
But when I go to unload/load filament, works fine, and print starts fine
What has gone wrong?
Posted : 02/02/2025 6:13 am
Topic starter
answered:
RE: Extruder Error(s) after 6.2.0
Worse yet is after this all red screen error occurs, the printer just sits there and beeps, the json/printer/state is not updated to PAUSED/STOPPED/ERROR/ATTENTION so I am never notified 🙁
Posted : 02/02/2025 6:19 am
RE: Extruder Error(s) after 6.2.0
Check out https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/4400
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 03/02/2025 4:49 pm
RE:
I am getting this error on TH5. I have removed the cover to see if it will stop the error.
This post was modified 3 weeks ago by Macmagoo
Posted : 18/02/2025 10:48 pm