Notifications
Clear all
Stránka 2 / 2
Předchozí
RE: 6.4.0-alpha Firmware for Prusa XL
Bonjour,
I switched to the Alpha version, and I'm still experiencing the same problems mentioned above. I've checked everything: axis alignment, belt tension, etc. My belts were running at 77 Hz, so I increased the tension to 82 Hz. Since then, I haven't had any issues. I'm printing for over 12 hours without any crashes. Now I'm going to test it with multiple colors and will let you know how it goes.
MK3S+; Ender5/Matrix extrudeur
Napsal : 02/11/2025 7:02 pm
Stránka 2 / 2
Předchozí