Notifications
Clear all

Re-dock after Probes  

  RSS
Agkirk
(@agkirk)
Estimable Member
Re-dock after Probes

Why does the the carriage re-dock the print head after initial probing and wait for a minute before retrieving the same print head and start printing?

Publié : 23/10/2023 5:10 pm
Thomas Lynch
(@thomas-lynch)
Estimable Member
RE: Re-dock after Probes

Because the nozzle has to heat up to print temperature. It is only held at 170 degrees during initial probing .

Tom

Publié : 23/10/2023 7:03 pm
xilni
(@xilni)
Eminent Member
RE: Re-dock after Probes

 

Posted by: @thomas-lynch

Because the nozzle has to heat up to print temperature. It is only held at 170 degrees during initial probing .

Tom

 

This, to prevent nozzle filament oozing.

Publié : 24/10/2023 2:23 am
Partager :