Notifications
Clear all
Page 2 / 2
Prev
RE: First layer suddenly too high for one tool
Well... ask five people and you'll get ten results for how much is hand-tight in reproducable and measurable units. 🤣
I generally try to use defined torque values when ever possible. Expecially if written so in a documentation.
I must have missed that, it didn't even occur to me to torque these because my original brass nozzles were definitely not torqued down. I removed 4/5 using two fingers, so I assumed hand tight is enough. Which in this case means "not tight at all".
Posted : 01/03/2024 8:12 am
Page 2 / 2
Prev