Notifications
Clear all

Tilt Timing  

  RSS
Yash
 Yash
(@yash)
New Member
Tilt Timing

I actually want to reduce the curing time per layer because the time that I am using is very high and unncessary. I tried reducing the time but then the parts do not get printed completely but rather break at some points. Can I resolve this by lowering the tilt times?

Secondly, I am printing with a custom resin that has very high viscosity. Because of this the parts with hole openings tend to close up during printing. Any solution for this?

Opublikowany : 08/09/2021 12:54 pm
Share: