Avisos
Vaciar todo
Wierd behaviour during tilting
I noticed this happening after upgrading to the latest firmware. When a layer is finished and the resin tank moves down, it is moving very slowly with a weird humming noise and then after it travels around 10-15%, it goes down normally. This happens also when it is commíng back to level position where the last 10-15% travel it does very slowly with that noise again. My prints are getting de-laminated from the FEP but the layers are seperating which I believe is because of this very slow motion. Is my printer behaviour normal?
Respondido : 15/09/2021 2:26 pm