SLS1 Prints not sticking to build plate...

Dernier message

RSS

Keldrazi

(@keldrazi)

New Member

SLS1 Prints not sticking to build plate...

The printer worked great out of the box. I changed the FEP film and recalibrated the printer and now it doesn't print correctly. Nothing is sticking to the baseplate and I'm just getting the printed resin on the FEP film. I removed both the layers from the new FEP film and the calibration completed successfully. I am using the Prusa Tough White resin. Any ideas of what may be going wrong?

Publié : 23/09/2022 6:35 pm

cwbullet

(@cwbullet)

Membre

RE: SLS1 Prints not sticking to build plate...

I would contact support via chat.

--------------------
Chuck H
3D Printer Review Blog

Publié : 04/10/2022 10:28 am

Statistiques du forum

559 Forums

62.9 K Sujets

443.1 K Messages

19 En-ligne

67.7 K Membres

Le dernier des messages: Ethernet slower than Wi-Fi? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé