Calibration and Tower Offset

Dernier message

RSS

daniel.p10

(@daniel-p10)

Active Member

Calibration and Tower Offset

I have had my printer for 2 weeks now and I have had to calibrate the tower 4 times already. Is this normal to have to calibrate it so often? Also, what does the Tower Offset feature do? I can not find any documentation on this setting.

Publié : 02/12/2019 8:22 pm

Statistiques du forum

559 Forums

63.1 K Sujets

443.9 K Messages

20 En-ligne

68.1 K Membres

Le dernier des messages: What colors do you have loaded? Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé