Avisos
Vaciar todo
Thin layer of resin over FEP
So, after about my 6th print my FEP got a layer of grey resin over the whole of it. When cleaning out the extra resin from the tank I did manage to get the lower right corner "clean." My question is 1) do I need to replace the FEP? 2) Can I recover this FEP screen at all? 3) What caused this/ how do I prevent it from happening again?
Respondido : 16/04/2020 12:03 am
RE: Thin layer of resin over FEP
Hello
did you find a solution to this problem ? same for me 🙁
thanks
Respondido : 01/05/2022 7:58 am
Topic starter
answered:
RE: Thin layer of resin over FEP
I ended up just replacing the FEP with a new one. Its been 2 years since then, and it never happened again.
Respondido : 02/05/2022 3:19 pm