Notifications
Clear all
Settings for FormFutura Spectrum LCD resin
I want to print in purple and this color is not available in the Prusa portfolio of resins.
So after some searching I found the FormFutura Spectrum LCD resin.
To get up and running I wanted to use the following parameters:
- layer hight: 0.05mm
- exposure time: 3s
- initial exposure time: 40s
Now this is the first time I use a non-Prusa-profiled resin; please forgive me: I am very unsecure ... so any adice/help would be fantastic!
This topic was modified před 2 years by Thomas
Napsal : 17/09/2022 5:22 am
RE: Settings for FormFutura Spectrum LCD resin
I have used this on my resin printers. I used about the same settings.
--------------------
Chuck H
3D Printer Review Blog
Napsal : 19/09/2022 12:32 pm