Notifications
Clear all
resin sticking to FEP on half the print area
Installed a new LCD screen, calibrated it and had a few good prints. Now all models on the front half of the print sticks to the FEP but the rest prints just fine
I have changed FEP and printplate. After every change I recalibrate the printer still the same problem
Any suggestions as to what might be happening and how it could be fixed?
Publié : 27/11/2020 4:07 pm
Topic starter
answered:
RE: resin sticking to FEP on half the print area
just recalibrted again, just because I have no other idea what I can do, and the print succeded
Publié : 27/11/2020 4:39 pm
ss
That animates the intriguing bone! Here of course in case I endeavor an article I can pull off two or three additional areas!
Publié : 28/10/2021 12:30 pm