Notifications
Clear all

resin sticking to FEP on half the print area  

  RSS
EnigmaticD
(@enigmaticd)
New Member
resin sticking to FEP on half the print area

Installed a new LCD screen, calibrated it and had a few good prints. Now all models on the front half of the print sticks to the FEP but the rest prints just fine

I have changed FEP and printplate. After every change I recalibrate the printer still the same problem

Any suggestions as to what might be happening and how it could be fixed?

 

Publié : 27/11/2020 4:07 pm
EnigmaticD
(@enigmaticd)
New Member
Topic starter answered:
RE: resin sticking to FEP on half the print area

just recalibrted again, just because I have no other idea what I can do, and the print succeded

Publié : 27/11/2020 4:39 pm
Jeffery021
(@jeffery021)
New Member
ss

That animates the intriguing bone! Here of course in case I endeavor an article I can pull off two or three additional areas!

 

Publié : 28/10/2021 12:30 pm
Partager :