Español
Foros
English forum
Original Prusa MK3.5
Hardware, firmware and software help
X-axis won't home
 
Avisos
Vaciar todo

X-axis won't home  

    Último Mensaje
  RSS
cdeutsch
 cdeutsch
(@cdeutsch)
New Member
X-axis won't home

I just finished upgrading to 3.5 and now the X axis won't home .  This is not my video, but is doing the exact same thing.

https://www.reddit.com/r/prusa3d/comments/1axtiwf/issue_with_xaxis_homing_after_upgrading_to_mk35s/?utm_source=share&utm_medium=mweb3x&utm_name=post_embed&utm_term=1&utm_content=1

I have checked the tension on my belt, I have lubricated the rods and bearings, and I have checked to make sure the nylon filament is not in the channel with the belt.  What else can I try?  Frustration very high over here.

 

Respondido : 18/06/2024 9:07 pm
  Todos los debates del foro
  Anterior debate
Siguiente debate  
Etiquetas del debate:  x-axis (76), not homing (1),
Compartir: