MK3.5 Mosquito Magnum Hot End
I just finished upgrading my printer to a MK3.5, I have a Slice Engineering Mosquito Magnum hot end on it, and it won't pass a hot end heater test. It prints just fine, but it gives me a warning everytime that that I need to complete the initial checks. I suspect the large copper heat block on the hot end I have just heats slower than stock. I also tried the revo setting and that failed to.
Is there anyway to get it to stop telling me I need to run the initial checks or adjust something to get it to pass?
RE: MK3.5 Mosquito Magnum Hot End
Strange, I have the same setup and My printer pass all the test and it is printing fine.
I just finished upgrading my printer to a MK3.5, I have a Slice Engineering Mosquito Magnum hot end on it, and it won't pass a hot end heater test. It prints just fine, but it gives me a warning everytime that that I need to complete the initial checks. I suspect the large copper heat block on the hot end I have just heats slower than stock. I also tried the revo setting and that failed to.
Is there anyway to get it to stop telling me I need to run the initial checks or adjust something to get it to pass?
RE: MK3.5 Mosquito Magnum Hot End
I tried running the test a few more times and trying different settings. For what it's worth, the test eventually passed for me using the with sock setting.