Under extrusion ONLY in the center of the bed

Ultimi post

RSS

mgtarallo

(@mgtarallo)

Trusted Member

Under extrusion ONLY in the center of the bed

Hi Guys - I have the same exact issue as this (link below) - however I have 7x7 on and magnet compensation on and still getting this issue - I am constantly adjusting and fixing the bed with this unit. I don't have a clog and it is a brand new nozzle. I have fixed this before by heating the bed, removing the screws, and tightening etc. it seems to always come back - any ideas?

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-general-discussion-announcements-and-releases/first-layer-under-extrusion-only-in-the-center-of-the-bed/

Postato : 22/12/2023 2:42 pm

Statistiche Forum

565 Forum

63.6 K Discussioni

446.3 K Post

19 Online

69 K Utenti

Post recenti: My XL is now called Sir Clog-a-lot after upgrades. Any ideas? Ultimo utente registrato: twh344 Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso