English
Forums
English forum
Original Prusa MK3.5
General discussion, announcements and releases
Under extrusion ONLY in the center of the bed
 
Notifications
Clear all

Under extrusion ONLY in the center of the bed  

    Last Post
  RSS
mgtarallo
 mgtarallo
(@mgtarallo)
Trusted Member
Under extrusion ONLY in the center of the bed

Hi Guys - I have the same exact issue as this (link below) - however I have 7x7 on and magnet compensation on and still getting this issue - I am constantly adjusting and fixing the bed with this unit.  I don't have a clog and it is a brand new nozzle. I have fixed this before by heating the bed, removing the screws, and tightening etc. it seems to always come back - any ideas?

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-general-discussion-announcements-and-releases/first-layer-under-extrusion-only-in-the-center-of-the-bed/

Posted : 22/12/2023 2:42 pm
  All forum topics
  Previous Topic
Next Topic  
Share: