Notifiche
Cancella tutti
Print Fan Issue
Hello,
I've ran into a issue as of yesterday trying to do a print. I noticed as my printer was going to start the print i realized that the filament looked like little bubble mountains and begun the good ole spaghetti from hell. Upon investigating i realized my print fan isn't on. So I did the wizard test over, both fans spin, both got a ok, great. Tried printing again.....print fan is off but the hotend fan is forever spinning. I manually set the fan to spin 255, go to print, it shut off and causing the same issue above. I know its not the gcode file because i printed a tower temp test yesterday with it. Tried a self test as well no luck. Anyone have a clue as to why this just started happening randomly?
Postato : 30/07/2024 7:10 am