Notifications
Clear all
MK3S+ using Prusaslice 2.7.1
I have just installed Prusa Slicer 2.7.1 and updated the printer firmware to 3.13.2.
I select the printer fore i3MK3S & MK3s+MMU3 single.
When I load the file from the SD card, I get this text "G-code sliced for different printer type. Continue? Yes No."
I accept Yes.
The model prints successfully , then unloads the filament.
Am I using the wrong slicer? and why is the Filament unloading.
This problem started when I installed 2.7.1
Napsal : 13/02/2024 4:14 am