Avisos
Vaciar todo
Mk3.5 always performs X and Y calibration.
My Mk3.5 has always performed flawlessly and still does, but now, after a power on and then the start of the first print, it always performs an X and Y calibration, which it has never done in the past. Thinking back I can't remember if it occured after burning the latest firmware. Is this a feature of the latest firmware, or do I have a problem?
Best Answer by FoxRun3D:
It's a "feature" of the firmware. My Mk3.5 and Mk4S's all do it. And annoyingly often.
Respondido : 22/10/2024 8:48 am
RE: Mk3.5 always performs X and Y calibration.
It's a "feature" of the firmware. My Mk3.5 and Mk4S's all do it. And annoyingly often.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Respondido : 22/10/2024 11:15 am
Topic starter
answered:
RE: Mk3.5 always performs X and Y calibration.
Ah well, at least I know I don't have a fault. Hoping they'll remove the "feature" soon, as the printer works fine without it!!
Respondido : 22/10/2024 12:01 pm