Notifications
Clear all

Help diagnosing and resolving vibrating MK3S+  

  RSS
KSU_Printer
(@ksu_printer)
Member
Help diagnosing and resolving vibrating MK3S+

Oddly enough, this just started after updating the firmware.  It's also worth noting the printer sat about a month between uses.  No other changes have been made. Printer is completely stock.

Prusa MK3S+ vibration

Posted : 09/01/2024 9:06 pm
Diem
 Diem
(@diem)
Illustrious Member

The three common reasons for prints suddenly failing after a printer has been unused for a while:

A dirty print bed. Give it a really thorough clean and avoid touching the print area.

Damp filament. Look up threads here about drying filament especially if it has been left open.

And - this is where you might start:

General neglect, dust and cobwebs... Basic cleaning, lubrication and general maintenance have all been missed.

See:  https://help.prusa3d.com/en/article/i3-printers-regular-maintenance_2072

https://help.prusa3d.com/guide/maintenance-tips_23200

Cheerio,

Posted : 10/01/2024 2:48 am
Share: