Notifications
Clear all
Top layer porosity
Guys,
So I finally got this thing printed. I'm pretty happy with it, but I see an issue that I can't seem to figure out what caused it.
If you look at the lettering, there's some considerable porosity in the top layer that is obviously NOT supposed to be there. The curious thing is that, when I printed a model that I had cut just under the base layer under the graphic portion and shrunk it (so save filament), it did this in the exact same manner.
See attached 3mf file for setting. For the most part, they are left default. Printing with Inland Tough PLA, all colors.
Anybody have any suggestions?
Thanks. Brad.
Posted : 06/11/2023 11:40 pm
Topic starter
answered:
RE: Top layer porosity
Guys,
Well... I THOUGHT I had attached a 3mf file, but don't see it. Anybody have any guidance on THAT, as well....?
Thanks. Brad.
Posted : 06/11/2023 11:43 pm