MMU3_3.0.0+814 suggestion
I installed the new MMU & MK3S+ firmware on my MK3S+ and MMU2s. In general- great improvement, thanks for making this available! Loading / unloading moves are more confident, and problems are much easier to diagnose and fix.
Suggestion:
- Add additional option other than 'retry' when a MMU failure is detected- a 'park selector' option would be very helpful - many failures I've seen require fixing the end of the filament, or repositioning filament in idler- which is quite difficult when selector is parked in front of the filement in question. So I have been hitting 'retry' then madly trying to effect the fix when the selector is running the cycle.
thanks!
RE:
I installed the new MMU & MK3S+ firmware on my MK3S+ and MMU2s. In general- great improvement, thanks for making this available! Loading / unloading moves are more confident, and problems are much easier to diagnose and fix.
Suggestion:
- Add additional option other than 'retry' when a MMU failure is detected- a 'park selector' option would be very helpful - many failures I've seen require fixing the end of the filament, or repositioning filament in idler- which is quite difficult when selector is parked in front of the filement in question. So I have been hitting 'retry' then madly trying to effect the fix when the selector is running the cycle.
thanks!
Also a "stop" button, to stop the whole print would be nice. Right now only way to stop is to reset the printer... But I guess we should open a feature request on github, but I am sure there is one already...
RE: MMU3_3.0.0+814 suggestion
I installed the new MMU & MK3S+ firmware on my MK3S+ and MMU2s. In general- great improvement, thanks for making this available! Loading / unloading moves are more confident, and problems are much easier to diagnose and fix.
Good to know. Thanks! Wrong sub forum though...
If at first you don't succeed, skydiving is not for you.
Find out why this is pinned in the general section!