Notifications
Clear all
Stránka 2 / 2
Předchozí
RE: Single Material Mode - MMU3 with Prusa Mk4
Using the filament mapping but MMU3 not switching to other spool position on print.
Prusa Slicer 2.9
- Using non-MMU profile
MK4S
- MMU3 toggled "on"
- MMU3 has material 5 loaded
- Filament mapping pops up before print, select 1.material on left side and material 2 on right side column, Replace button, Print button.
I was expecting the MMU3 to change to material 2 but it just uses material 5 which was loaded prior to printing. Should the MMU3 switch to material 2 (isn't that the point of the filament mapping steps) ? Something in the setup I have listed? MMU3 is on, filament mapping coming up.
- thanks for any insight
Napsal : 10/01/2025 12:56 am
RE: Single Material Mode - MMU3 with Prusa Mk4
Restarting printer seemed to fix this (should have tried that first....)
Napsal : 10/01/2025 4:54 pm
Stránka 2 / 2
Předchozí