MMU3 support for the MK3.9?

Ultimi post

RSS

RCNet

(@rcnet)

Trusted Member

MMU3 support for the MK3.9?

Hi all,

Does anyone know if the MK3.9 is supported by the MMU3? I don't see anything specifically mentioning the MK3.9 in the MMU3 blog post or on the Prusa store page, but from the MMU point of view, the MK3.9 and MK4 are essentially the same printer, and now with the release of 5.0.0 even share the same firmware.

Thanks!!
RCNet

Postato : 09/10/2023 1:48 am

Hello

(@hello)

Noble Member

RE: MMU3 support for the MK3.9?

Posted by: @rcnet

Hi all,

Does anyone know if the MK3.9 is supported by the MMU3? I don't see anything specifically mentioning the MK3.9 in the MMU3 blog post or on the Prusa store page, but from the MMU point of view, the MK3.9 and MK4 are essentially the same printer, and now with the release of 5.0.0 even share the same firmware.

Thanks!!
RCNet

Id say it would same motherboard same dimensions same extruder same extrusion same firmware I don't see why not

Please help me out by downloading a model it's free and easy but really helps me out https://www.printables.com/@Hello_474427/models

Postato : 09/10/2023 3:54 am

Statistiche Forum

559 Forum

63.1 K Discussioni

443.8 K Post

20 Online

68 K Utenti

Post recenti: What colors do you have loaded? Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso