MMU separated from MK

Dernier message

RSS

Oregonerd

(@oregonerd)

Active Member

Separating the MMU from the printer to make it easier to remove the printer and work on in general. What do you think? Should I upload it?

I am not an engineer or an artist. I am a bit of a designer that does a little of both.

Publié : 05/03/2024 9:53 pm

Tim et DavyGD ont aimé

K7ZPJ

(@k7zpj)

Reputable Member

I would upload the model and see what comments it generates.

Publié : 05/03/2024 10:59 pm

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

24 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé