Print the parts with NGen?

Dernier message

RSS

Tellblom

(@tellblom)

Membre

Print the parts with NGen?

I have unopened Prusa NGEN roll. Can I print the mmu3 parts with that or does it gave to be PETG ?

Publié : 21/04/2024 7:27 am

jseyfert3

(@jseyfert3)

Reputable Member

RE: Print the parts with NGen?

I saw someone on Reddit had a problem with the MMU3 operating with ASA parts. They reprinted PETG parts and it worked. So I'd say try PETG first, make sure no issues, then only after you've verified it works try printing in other materials. That way, should any issues pop up, you know it's the other material and not some first time use error.

Publié : 01/05/2024 7:32 pm

Statistiques du forum

565 Forums

63.5 K Sujets

445.6 K Messages

23 En-ligne

68.7 K Membres

Le dernier des messages: Prusa XL mid-print filament change Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé